|
May 14th, 2009, 18:42 Posted By: wraggster
Its finally been released, heres the info:
BootMii is a set of software that can be installed on Nintendo Wii© consoles to provide added functionality, safety and convenience.
BootMii for Users:
BootMii is a piece of software that can be installed as an IOS or inserted into the boot process. As an IOS, it provides a fast way to back up your Wii's internal NAND flash memory, and will eventually form the basis of a new generation of homebrew applications for the Wii. Inserted into the boot process, BootMii provides you with a "safety net" -- you can back up your entire Wii to SD in under three minutes! If you were to brick your Wii, BootMii would still run and let you restore your backup from SD, quickly and painlessly. BootMii also allows you to directly boot the Homebrew channel or other homebrew from SD, bypassing the "warning screen" and the rest of the menu.
Coders:
You will have full access to both processors inside the Wii, and can inject code anywhere into the boot process. Want to write your own system menu? Stick it on your SD card and boot it. BootMii is powered by USBGecko -- as with the Homebrew Channel before it, you can upload code and run it via USBGecko. With BootMii, you can upload code to either processor a few seconds after poweron.
BootMii Installation
--------------------------------------------------------------------------------
BootMii installation is a breeze, if you are already capable of running Homebrew. In any case we recommend launching the BootMii Installer through the Homebrew Channel if you are already capable of running homebrew.
People who don't have the Homebrew Channel on theirs wii yet can use either the Twilight Hack or BannerBomb to launch our newly designed installer. We won't be describing these methods in detail here, read the respective documentation yourself to figure out that part.
The new installer has been revamped a bit in comparison to our old installers, and is actually not just an installer for BootMii, but will also allow you to install The Homebrew Channel and DVDx. So if you don't have the Homebrew Channel or DVDx yet, you can use above mentioned exploits and our single all-in-one installer to install everything in one go.
After launching the installer, just follow the instructions on screen and you should be good to go within a minute or two.
Download and Give Feedback Via Comments
For more information and downloads, click here!
There are 5 comments - Join In and Discuss Here
|
|